Tornado Strike Electronic Board, Handle K46832583

The Electronic Board (part# K46832583) is the control board that sits behind the Tornado Strike’s handle. It reads the operator’s switches, drives the display and passes instructions down to the motherboard in the body of the machine.

Compatible Models for the Electronic Board, Handle

• Tornado Strike Cordless Upright Vacuum — Model TV190-W10-U

This is a Strike-only component: Tacony’s parts records list the Tornado Strike TV190-W10-U as the single machine that takes part# K46832583, so there is no cross-model substitution to worry about when you order it.

What the Electronic Board, Handle does

On a battery machine the electronics do more than switch power. The handle board is where an operator’s press becomes a request, and it has to survive the environment of a commercial upright — vibration from two motors, temperature swings between a cold van and a heated building, and the occasional knock. It also has to fail safely: a board that loses contact with the motherboard should stop the machine rather than leave a brushroll turning.

Signs the Electronic Board, Handle needs replacing

Suspect it when the machine responds intermittently to its controls, when the display behaves erratically or shows states that do not match what the machine is doing, or when it will not start at all with a known-good battery and a charged pack. Visible signs are a cracked board, a browned or lifted component, or corrosion around the connector. Before condemning it, unplug and reseat the handle loom — a dirty connector causes all of the same symptoms for nothing.

Fitting the Electronic Board, Handle

Split the handle, unplug the board and note every connector position before anything comes off. Handle the replacement by its edges and keep it away from grit; these are not sealed assemblies. Seat each connector fully, make sure no wire is pinched in the handle joint, then close up and run the machine through every control and every setting to confirm the board is reading and driving correctly.

Twin City Vacuum has been selling and servicing Tornado equipment since 1956. You can browse the rest of the machine on our Tornado Strike parts pages, and the manufacturer publishes specifications at tornadovac.com.

Frequently Asked Questions

What does the handle Electronic Board do on the Tornado Strike?

It is the control board behind the handle. It reads the operator controls, drives the display, and relays instructions to the motherboard in the machine body.

How do I know if my handle Electronic Board needs replacing?

Intermittent response from the controls, a display showing states that do not match what the machine is doing, or a machine that will not start with a known-good charged battery. Reseat the handle loom connector first — a dirty connector mimics every one of these.

What models is the Electronic Board, Handle (part# K46832583) compatible with?

The Tornado Strike TV190-W10-U cordless upright vacuum, and only that machine. Tacony’s parts records list no other model that takes part# K46832583.

How do I order the Electronic Board, Handle (part# K46832583) or get help?

You can add the Electronic Board, Handle (part# K46832583) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 has been servicing Tornado equipment since 1956 and can help confirm the right part for your machine.

Questions? Call us at 763-535-0770 or visit us at 5415 West Broadway, Crystal, MN 55428.