Tornado Strike Top Cover, Brush Housing K47756190

The Top Cover for the brush housing (part# K47756190) is the removable lid over the Tornado Strike’s brush head. It closes the airflow path across the top of the brushroll and it is the panel that comes off every time the belt or roll needs attention — which is exactly why it is a part that gets damaged on a machine in daily service.

Compatible Models for the Top Cover, Brush Housing

• Tornado Strike Cordless Upright Vacuum — Model TV190-W10-U

This is a Strike-only component: Tacony’s parts records list the Tornado Strike TV190-W10-U as the single machine that takes part# K47756190, so there is no cross-model substitution to worry about when you order it.

What the Top Cover, Brush Housing does

The cover does two jobs at once. It seals the top of the brush chamber so that the suction generated at the other end of the machine actually pulls through the carpet rather than through a gap, and it keeps fingers, cords and carpet fringe away from a roll turning under power. A cover that no longer clips down flat costs airflow at the point where the machine picks up dirt, so the loss shows as poor pick-up rather than as an obvious fault.

Signs the Top Cover, Brush Housing needs replacing

Replace the cover when its clips or tabs have snapped and it no longer sits flush, when it is cracked through, or when it has warped enough that a visible gap runs along one edge with the cover closed. Reduced pick-up on carpet that survives a bag change and a clear brushroll is often a cover that is not sealing. Deep gouging on the underside from a roll that has been running against it is another reason to change it rather than refit it.

Fitting the Top Cover, Brush Housing

It is a tool-light job on most machines: release the retaining screws, lift the cover clear, and check the mating face on the housing for debris or a distorted lip before the new one goes on. Seat the replacement squarely, start all its screws by hand before tightening any of them so the cover is not pulled crooked, and confirm it closes flush all the way round with no daylight along the edges.

Twin City Vacuum has been selling and servicing Tornado equipment since 1956. You can browse the rest of the machine on our Tornado Strike parts pages, and the manufacturer publishes specifications at tornadovac.com.

Frequently Asked Questions

What does the brush housing Top Cover do on the Tornado Strike?

It seals the top of the brush chamber so suction pulls through the carpet instead of through a gap, guards the turning brushroll, and lifts off to give access to the belt and roll for servicing.

How do I know if my brush housing Top Cover needs replacing?

Snapped clips, a crack through the panel, or a warp that leaves a visible gap along an edge when it is closed. Pick-up that stays poor after a bag change and a clear brushroll is often a cover that has stopped sealing.

What models is the Top Cover, Brush Housing (part# K47756190) compatible with?

The Tornado Strike TV190-W10-U cordless upright vacuum, and only that machine. Tacony’s parts records list no other model that takes part# K47756190.

How do I order the Top Cover, Brush Housing (part# K47756190) or get help?

You can add the Top Cover, Brush Housing (part# K47756190) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 has been servicing Tornado equipment since 1956 and can help confirm the right part for your machine.

Questions? Call us at 763-535-0770 or visit us at 5415 West Broadway, Crystal, MN 55428.