Mytee HP90 Stingray Parts

Genuine Mytee HP90 parts for Models HP90 and HP90-SS, from Mytee’s parts book. Find your part on the Mytee HP90 Stingray parts diagrams; the full guide and FAQ are below the parts.

Showing 1–20 of 65 results

Mytee HP90 parts for Models HP90 and HP90-SS

This category holds every Mytee HP90 part we stock for the HP90 Stingray heated automotive detailing extractor, Model HP90 and Model HP90-SS. Both models share one Mytee parts book; the HP90-SS is the same machine supplied with a stainless steel upholstery tool. To find a part by where it sits on the machine, open the Mytee HP90 Stingray parts hub and click it on Mytee’s factory drawing.

What you will find here

First, the solution side: the strainer, quick disconnects and brass fittings, the 48-inch internal solution hose and the faucet-fill adapter.Next, the base and pump. This includes the C305 120 PSI pump, its relief and check valves, the pulse hose, the 3-inch locking casters and the 25-foot 12/3 power cord.Then the recovery side. Here you will find the clear 7-inch lid and gasket, the E373 float switch and E632 relay, the inlet elbow and filters, the drain valve and the C302LA vacuum motor.Finally, the heater. We stock the complete A907 1,200-watt heater as well as its castings, heating rods and thermostats.

Choosing the right Mytee HP90 part

Most HP90 parts are shared with other Mytee machines. For that reason, each product page lists every model whose Mytee parts book includes that part number.Weak suction is usually an air leak at the lid gasket, the drain valve or a Cuff-Lynx connection. Weak spray usually starts at the strainer or a quick disconnect. Cold solution, on the other hand, points to a heating rod or thermostat.You can also shop the Mytee HP90 Stingray machine, see the full Mytee lineup, browse parts for every Mytee machine, or read about the machine on mytee.com. Twin City Vacuum has sold and serviced cleaning equipment since 1956 at 5415 West Broadway, Crystal, MN 55428. Call 763-535-0770.

Frequently Asked Questions

Do Mytee HP90 parts fit the HP90-SS?

Yes. The HP90 and HP90-SS share one Mytee parts book. The HP90-SS is the same machine supplied with a stainless steel upholstery tool.

Which HP90 parts wear out most often?

The 7-inch vacuum lid gasket, the screen and foam filters, the vacuum motor gaskets, the Cuff-Lynx connectors, the drain valve and the quick disconnects. On the heater, the E571 rods and the thermostats are sold separately.

What if a part on the HP90 parts list says Call?

Mytee does not sell every tank, lid and fastener on its website. Call 763-535-0770 with the part number and we will order it for you.