Tornado Brute Force 2000 98486 Dust Control Skirt X1461
$150.99
Genuine OEM dust control skirt (part# X1461) for the Tornado Brute Force 2000 High-Speed Glazer with Dust Control, Model 98486 — the floor seal that keeps burnishing dust inside the machine. Shown on the current main body drawing.
The X1461 dust control skirt is the flexible seal that runs around the pad area on the Brute Force 2000 Dust Control glazer (Model 98486). It appears on the current 14 July 2025 main body drawing and on the earlier 29 December 2022 main assembly. The 98482B glazer has no equivalent part because it has no dust-control system, so this skirt is specific to the 98486. It is a shared part used across Tornado machines — see the full list of models below.
The skirt is what makes dust control work. A burnisher at 2,000 RPM throws a fine cloud of abraded floor finish off the pad; the skirt keeps that cloud inside the shroud where the airflow can pull it into the filter (19069). If the seal to the floor is broken anywhere around its circumference, the machine will take the easy path and pull air in through the gap instead of across the pad, and most of the dust escapes into the room.
Replace the X1461 when it is torn, when the edge has worn back so it no longer touches the floor, when it has taken a set and curls away from the floor, or when it has gone hard and stopped conforming to surface irregularities. The symptom is unmistakable: a machine that used to run clean starts leaving a dust haze on baseboards and nearby surfaces. Check the skirt before you suspect the filter — a torn skirt and a loaded filter look identical from across the room, and the skirt is the cheaper and more common failure.
When fitting a new skirt, check the dust skirt clamp (X1469) and the hardware that holds it: a good skirt held by a loose clamp seals no better than a worn one. Set the skirt so it just contacts the floor with the machine at working height — too high and it leaks, too low and it drags and wears out quickly. Call 763-535-0770 with your model and serial number if you want the dust-control set listed for your vintage of 98486.
Compatible Models
- Tornado models:
Frequently asked questions
What does the dust control skirt (part# X1461) do on the Tornado 98486?
It seals the pad area to the floor so the dust thrown off the pad stays inside the shroud, where the machine’s airflow can carry it into the filter instead of into the room.
How do I know if my X1461 dust control skirt needs replacing?
Replace it if it is torn, worn back from the floor, curled or hardened. The giveaway is a machine that starts leaving a dust haze on baseboards and nearby surfaces when it used to run clean.
Dust is escaping — is it the skirt or the filter?
Check the skirt first. A torn or worn skirt is the more common and cheaper failure, and it lets the machine pull air through the gap rather than across the pad. Then check the filter (19069) and the skirt clamp (X1469).
What models is the dust control skirt (part# X1461) compatible with?
The Tornado Brute Force 2000 High-Speed Glazer with Dust Control, Model 98486, on both its current and earlier drawings. The 98482B has no dust-control system and no equivalent part.
How do I order the dust control skirt (part# X1461) or get help?
You can add the dust control skirt (part# X1461) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 can help you find the right part for your machine.






Reviews
There are no reviews yet